Paver sealing for Cape Coral homes

A side service, not the main work

Sealing is a side service on this site, not the main work. It is for homeowners who already have a paver surface and want to protect it, refresh its color, and hold the joint sand in place. The service matches homeowners in Cape Coral with local installers who take sealing work, and those installers visit, inspect the surface, and price the sealing for that area. Sealing over dirt, stains, or failed joints locks those problems in, so cleaning and joint repair should come first.

It starts with cleaning

A sealing job usually starts with cleaning. Dirt, mildew, algae, and stains are removed, and the surface is allowed to dry. Joint sand that has washed out is replaced, often with polymeric sand that hardens in the joints and resists washout and weeds. Only then is sealer applied. The type of sealer matters. A film forming sealer sits on the surface and can give a wet look or a matte finish. A penetrating sealer soaks into natural stone and protects it without a thick surface coat. The two should not be swapped without advice, especially for travertine or natural stone.

What sealing costs

Published Florida guides put professional paver sealing at $1.25 to $3.50 per square foot, with a 1,000 square foot driveway at $1,250 to $3,500 and a 600 square foot pool deck at $750 to $2,100 in one guide. Another Florida guide puts the average for a proper service at $0.90 to $1.25 per square foot. The spread is wide because condition, cleaning, sand replacement, sealer type, and access all change the price. A surface with heavy staining, old sealer removal, or missing sand will cost more than a clean surface that only needs a recoat.

When to seal

Timing matters for sealing. New pavers should not be sealed at once in every case, because some materials need time to weather and for mineral bloom to clear. Old sealer that is peeling or blotchy may need stripping before a new coat, and that is a separate labor item. Ask the installer how long after cleaning the surface must dry, whether old sealer will be stripped, and what finish the new sealer will give. A pool deck should not be sealed with a glossy finish that reduces grip when wet, and a shaded patio may need more cleaning for algae before sealing.

Sealing will not fix a failed surface

Sealing is not a fix for a failed surface. If pavers are sinking, rocking, or spreading at the edges, the base or the edge restraint has failed, and sealing over that problem will not hold it. In that case, repair and leveling should come first, and sealing should follow once the surface is flat again. Ask the installer to inspect the surface and to tell you plainly whether sealing alone is enough, or whether repair is needed first. A good installer will say no to sealing a surface that needs repair, even if that means a smaller job in the short term.

What to ask at the visit

When the installer visits, ask for cleaning, sand replacement, sealer type, number of coats, finish, and any stripping as separate lines. Ask when the surface can be walked on and when vehicles can use it. Ask what cleaning products are safe for the sealer, and how long the sealer should last on a driveway, a patio, or a pool deck in Southwest Florida sun and rain. Those answers make a sealing bid possible to compare, and they prevent a low bid that skips cleaning and sand from being compared with a full service bid.

Cape Coral Paver Pros is a referral service, not a contractor. Work is done by independent, licensed local contractors.